Bearing Holder for Type 608
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Bearing Holder for Type 608 with a hex pattern.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 225
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
This model is a bearing holder for 608Z (22 mm x 7 mm) bearings.
It is a remnant of my toilet paper holder, where the version with bearings was a bit overengineered and failed at its task so I did't use it there.
But it is a nice model so I share it incase maybe someone might find it useful.
Size: 95 x 80 x 21 mm
For mounting there are two 5mm hexagonal holes on the side.
The bearing is a press-fit. For testing and adjusting the model to factor in your bearings and printer calibration there is a seperate file for a tolerance test. Print it at 100% and insert a bearing. If it doesn't fit to your liking (too loose, too tight) then adjust your print scale by 1-2% and try again. Then print the main model.
Printed in Creality PLA black on Elegoo Neptune 4 Pro with:
- Layer: 0,3 mm
- Infill: 25% Cubic
- Wall Line Count: 5
- Print orientation as in file
- Support: no
- Ironing: yes, if wanted (ironing makes a nicer look)
Change the parameters depending on your needs and use case.
Happy printing!