PTFE Tube Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this to tidy up and organize all of the PTFE tubes when using a prusa MMU
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 169
- Wydruki
- 0
- Wyświetlenia
- 635
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The first thing I noticed after installing my MMU3 is that you have PTFE tubes EVERYWHERE! While Prusa was good enough to provide several of these for tidying things up, they really don't want to stay put because they do not have a cover. That is where my PTFE Tube Organizers take over.
This simply clips over and around the PTFE tubes and simply snaps closed preventing them from popping out. This organizer stays clipped firmly in place and retains the tubes from coming out when moving equipment around. They are also printed in one piece and are easily installed.
Here are the settings that I used:
- .20 mm layer height
- .4 mm nozzle
- 100% infill
- Rafts: No
- Supports: No
- 4 Layers top and bottom
I used PLA, but there is no reason why whatever filament you happen to be using wouldn't work.
How to use this tool:
- Start by inserting each of your PTFE tubes in the order you desire.
- Snap the top section of the clip closed and press until you hear a click.
- To open, you may have to use a small screwdriver to pry out the latch enough to release the clip.