Gift Bow for Imprint Build Plates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Christmas Gift Bow from Bjørn Frihagen, which allows you to have build plate side on the whole front of the bow
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 160
- Wydruki
- 4
- Wyświetlenia
- 742
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Christmas Gift Bow from Bjørn Frihagen is amazing. However, as I have some “fancy” PEO/PEY/PET buildplates that leave imprints on the first layer, I wanted to remix the original so I could show these imprints on the full front of the bow.
I also added some holes, similar to the remix of existant_person so you can tie the bow to a christmas or use it with a safety pin to pin it on your clothes like the remix IBNobody. In order to accomodate one extra layer I also increased the lenght of the pin.
If needed I can make some extra guidlines on how to fold this bow.
I have used the recommendations of IBNobody to print in:
- Top Fill Pattern: Monotonic Lines
- Bottom Fill Pattern: Concentric
- Fill Angle: 180 (for Monotonic Lines)