Dyson v6 Stickvac fluffy head wall mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Excuse my 1st fusion360, paired wall mounts fits the both v6 fluffy & direct drive heads hang w #6 miter wood screws
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 522
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Needed a way to hang dyson v6 accessories & heads, just wasn't finding a fluffy solution I liked, so I whipped this paired set up.
Excuse my 1st fusion 360 design. Been doing autocad design 35 yrs, so this was a little too freewheeling to me at 1st.
The wall mounts are end cap style & fits both v6 fluffy and the direct drive 23cm head.
Should fit other models too, but no guarantee, YMMV.
Included fusion360 .stl & cura lulzbot edition .gcode is set for Lulzbot Taz 4 & 2.85 filament.
.zip contains both.
I printed in pla, 2 walls/faces, 20% infill, 90% feedrate, brimmed
Should fit off the plate.
Designed to be hung w #6 miter wood screws, you may need to bore the hole out depending on your screws.