Incense stick holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a typical Incense Stick Holder Should fit nearly all common incense sticks. Except a log of wood...obviously
- Ocena
- 4,5 / 5
- Polubienia
- 43
- Pobrania
- 307
- Wydruki
- 4
- Wyświetlenia
- 794
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial
3d printed Incense Stick Holder
Should probably fit all common incence sticks since they are “all” the same.
(Except a log of wood…maybe. If you try, post a make, thanks)
Printed it laying down on the side. (That was a little bit of a challenge but I wanted to get the smoothest surface) Use a Raft. Didn't try it without but I think you might will have problems with bed adhesions since the surface facing the bed is approx 0.6mm.
Printspeed: 30mm/s
Layer: 0,1mm
Filament: Elegoo PLA+ White
Temp: 215 / 60
Support: NO
Raft: YES!!!
I attached the STL, STEP and f3d but if you want to have something changed, just reach out to me or learn how to do it yourself in Fusion.
If you like my work, feel free to send me some virtual coffee (=money…obviously)
https://www.buymeacoffee.com/mikeusual
DISCLAIMER
I am not responsible if you burn your house down.
You should never leave anything unattended, especially if something might cause a f**** fire.
Use your brain!