Remixed Advanced Filtration System

I wanted to add a filter to my Prusa Enclosure but wanted to use my own supply of filters so that I can get replacement filters both easier and cheaper. I also wanted to use 12 volts as I have a 12v power supply feeding my lights, so I remixed the Prusa version. I've included STEP and Fusion 360 files so if anyone wants to change to another filter they can have a easier starting position than from an stl. I have included a mount for a switch on the bracket, if you don't want this you you can delete the last five steps in the f3d file.

The filters I used are described as for a Levoit LV-H128, PUURVSAS HM669A or ROVACS RV60; part number LV-H128-RF, see below for link to them on the Amazon UK site. Instructions for assembly are the same as the Prusa official filter (https://help.prusa3d.com/guide/7-advanced-filtration-system-add-on_361946). Rather than mount in the right rear corner of the enclosure, I choose to mount it in the left rear as that is where my 12 volt power supply is. The fan I used was 12 volts but there are fans generally available in the same shape in multiple voltages)

To this you will need:

• Filters (https://www.amazon.co.uk/dp/B0CD7PTGWL or https://www.amazon.co.uk/s?k=%23LV-H128-RF)
• Fan (https://www.amazon.co.uk/dp/B0BYJB3TSB)
• M4x16b countersunk screw (2x)
• M3x8 screw (4x)
• Dampers (4x) (https://www.amazon.co.uk/dp/B0BM8TC64R)
• 92x3mm O-Ring (https://www.ebay.co.uk/itm/186154048550 you can buy these in the UK for faster delivery but for a lot higher unit cost)
• M3 Nuts (x4), you can use thumb nuts as on the Prusa Official or normal hex nuts
• Wire, power supply and switches for however  you choose to do the wiring.