Bambu Lab P1P/S Top Mount Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added a slot to account for longer walls and back with the official Bambu sides and rear on the P1P/S
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 146
- Wydruki
- 0
- Wyświetlenia
- 1454
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I really liked the spool holder https://www.printables.com/model/381648-bambu-p1p-carbon-top-filament-spool-holder.
But I added the Bambu walls and back only from the P1S to my P1P's, this meant there was a raised area not accounted for in the original design, the mounting screws didn't line up.
Rather than trying to cut the plates and rear, I simply added a slot to the original design for that purpose, this will work on a P1S BUT not with the glass on.
If you print with the glass off it won't make a difference to you, i.e PLA, PETG.
I printed in PETG
No raft, support or brim,
5 Walls Bottom and Top
30% infill.
A tip check to make sure the filament flows though before you pop in on, one of mine had a bit of stuck filament in it.