MTW Midcap GEN-1 Upgrade Follower
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Upgrade follower for GEN-1 MTW Midcaps
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 100
- Wydruki
- 0
- Wyświetlenia
- 456
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original MTW midcaps tend to hold onto one bb that they will not release, making it look like you still have bbs in your magazine. This extended follower makes sure that your magazine will eject the last bb and still actuate the stop on empty micro switch.
I have printed a few of these and done some minimal testing. So far and they seem to work fine.
Depending on your printer you may have to sand the sides of the peg that actuates the stop on empty bar to get the follower to travel smoothly around the curves in the magazine.
*************
V4 - After trying the model for a while, I was consistently having issues with BBs getting inline with the end of the follower.
*************
V5 - Updated to cup the first BB and prevent it from jamming inline with the end of the follower.
*************
V6 - V4 follower was getting canted too much in the BB track and still jamming. Made a rough copy of the proportions of the Gen2 MTW magazine follower. I have not tested much, but it seems that the longer follower prevents the follower from being able to be twisted in the BB track.
As a side benefit, feeding speed seems to have been improved and I was able to load 130 BBs vs the ~110 from the previous designs.