xTool P2 Exhaust Duct (right angle with quick-disconnect)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an exhaust duct for the xTool P2 CO2 laser that allows it to go up against a wall.
- Ocena
- 0 / 5
- Polubienia
- 50
- Pobrania
- 260
- Wydruki
- 1
- Wyświetlenia
- 2162
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
This exhaust duct attaches directly to the back of an xTool P2, replacing the existing duct. It lets you fit the whole machine closer to a wall and vent the exhaust left or right. There is a feature for adding a zip-tie to secure to the back of the machine. It adapts to a quick-disconnect duct. The magnets are 12mm x 8mm N52. They are press-fit, but glue can be added if necessary. There is a small boss on the elbow of the duct. Place the part on this face and print at a 45 degree angle as shown above. Organic supports work well and you should get a pretty clean part at 0.2mm layer height.
The duct coupler uses the same magnets and is made for a 3.5" hose. It gets printed face-down (handle pointing up). No supports are necessary as long as you can bridge reasonably well. There is a drawing for the coupler if you'd like to design your own.