Jar label applicator v.1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Symmetric Jar label applicator for 70mm (diameter) jars,
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 108
- Wydruki
- 0
- Wyświetlenia
- 1584
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
I've created symmetrical jar labeler for you to print and use - it is not perfect - but it is free ;)
Notes:
- “Jar holder” part, has to be mounted about 10mm under “label_separator”,
- “upper_limiter” part, is optional andprevents label of popping out throught the top,
- “separator” part, is sitting on the top of five spacers - these spacers are basically responsible for the location of the label on the jar,
- “winder_core” part may still need to be re-worked as it is very tight fit with M5 nut,
- “winder” part may have to be splitted on the bottom for easier backing removal,
- “winder_handle” part is to be glued in to “winder” part,
- “sponge_holder” part has to be mounted and adjusted individually - depending from the type of sponge you are using.
As device is symmetric, it can be used with rolls either way, but “leading” part has to be flipped, so mounting it with wingnuts might be a good idea.
All bolt holes are M5.
note: certain parts areupdatedand being marked as V2 etc.
https://www.buymeacoffee.com/maxplanck