Honeycomb Wall Holder for Brennenstuhl PL 200 flashlight
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Honeycomb Storage Wall (HSW) holder for the Brennenstuhl PL 200 flashlight
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 237
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
This is a holder keeping your Brennenstuhl PL 200 flashlight nicely on your Honeycomb Storage Wall (HSW) for easy retrieval. The model was designed for the PL 200 AC model, but should fit the other model variants as well.
What is needed?
- print model either from the provided step or stl
- no additional inserts needed
How to print
Use support for insert attached to the holder model. Or print without support and make manual corrections (e.g. by pulling off some unclean parts with pliers or by sanding a little - for me, this was perfectly fine).
I suggest to stick with the original suggestions for printing holders and inserts for the honeycomb wall: Use any material you like (I used red PETG), with layer height of 0.2mm, 4 perimeters and 20% infill.