1 / 5
Hutermann Tondo PIR sensor outdoor cover + pole holder (45 deg.) — zdjęcie 1
1 / 5

Hutermann Tondo PIR sensor outdoor cover + pole holder (45 deg.)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Outdoor cover for Hutermann Tondo PIR sensor, otherwise commonly used indoors.

Ocena
0 / 5
Polubienia
0
Pobrania
16
Wydruki
0
Wyświetlenia
141
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

https://www.hutermann.cz/produkt/pohybove-pir-cidlo-infraspinac-pohybu-stropni-hutermann-360-stupnu-3310-tondo

Pictures are self-explaining. Angle of the holder is 45 degrees. Holder and cover are screwed together from inner side of the cover. There is a thin auxiliar line on the bottom of the cover-from inside. Drill a hole through then screw the two parts together. On the bottom is a blinded grommet, drill it too according your cable. There is enough place under the sensor for WAGO clamp for connecting the ground wire.

I printed it with PETG and 0.25mm layer. No supports.