1 / 2
Voron 2.4 350 HF Yukon Cabinet Printer Foot Extension Brackets — zdjęcie 1
1 / 2

Voron 2.4 350 HF Yukon Cabinet Printer Foot Extension Brackets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Extension brackets that allow a Voron 2.4 350 to sit on it

Ocena
0 / 5
Polubienia
0
Pobrania
12
Wydruki
0
Wyświetlenia
309
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Picked up a HF Yukon cabinet for setting my Voron 2.4 350 on.  It was just a little shallow in depth so I designed these to bolt to the back so the rear feet would have something to set on.  

The side with the bevel in the middle face aligns with the bevel on the back of the cabinet from the sheet metal fold.  You will need to drill a hole for a bolt, washer, and nut in the larger slot.  I used the largest bolt I had that fit the slot but it doesn't have to be a long one (something in the 3/8" x 1" range).  The bottom slot used a self tapping sheet metal screw.  The pad piece gives the ability to raise up bracket platform in case your measurements were off a bit, but isn't expressly needed.

Print with the open 45 degree side down on the build plate and you will not need supports

It is this cabinet and is outstanding as a printer work area and storage:

 https://www.harborfreight.com/tool-storage-organization/yukon-tool-storage/46-in-9-drawer-mobile-storage-cabinet-with-solid-wood-top-black-56613.html

Tagi