Sink Sponge Holder - Holds two sponges (70 x 50 mm each) to keep them off the windowsill or counter top
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple sponge holder to keep your kitchen clean and tidy.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
Sponge slots are 70 x 50mm.
This is quite straight forward, it is a holder for your dish washing sponges. It holds them up to dry and keeps them from cluttering the place.
We live in hard water area, so capturing the water and soap from the sponges is better than having it drain into the sink and then becoming very hard to clean.
There is plenty of space for sponges. The sponge slots are 70 x 50mm, they can be as tall as you like. this is low profile from front to back, as out sink as you can see has little room between the wall and the sink.
This doesn't have any support at the back, as it balances itself reasonably well. I have a model with a foot at the back, but it requires support to print and I decided this one was more useful, even if slightly less perfect.
All the sides are chamfered or filleted, as appropriate to give a nice look and feel with easy printing.
I used my normal PETG settings, nothing clever and nothing special. Use the one that works well for you.
- Nozzle: 0.4mm
- Layer height: 0.2
The part prints with the bottom on the print bed, PETG prints slowly for me, but this didn't take all that long.
Material
I used a Black PETG for this one, and it should be water tight (enough) for this application.
If you use PLA, use a sealer, such as a Conformal Silicon coating or epoxy. It depends of course how much water you expect and how often you will clean it out.