Kobra 2 Plus filament relocation and cable organizer V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
parts for relocating your filament sensor and managing the cables a bit better.
- Ocena
- 0 / 5
- Polubienia
- 37
- Pobrania
- 258
- Wydruki
- 0
- Wyświetlenia
- 2018
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
ATTENTION: because of the cable length only being just long enough. arranging your cable like this will remove about 6cm of your build volume height, so your total volume would be 32x32x34
V2:
Adjusted the fit so they hold together better, and tiltet the spool holder because it drooped after some time.
you will need to print
1 “Filament holder”
1 “Cable track base”
1 “Cable track top”
1 “Filament sensor holder”
22 “Cable track” (maybe fewer or more if you have the Kobra 2 Pro or Max)
To get the "Cable track base" in place, you must remove the cover on the aluminum extrusion shown below. It should be about 12cm from the front. Zip-tie the cable in place on the “Cable track base”
To mount the “Filament holder” unscrew the 2 screws holding the top of the right-hand side Z-rod stabilizer and belt tension. when you screw the “Filament holder” in place remember to tension the belt that keeps the 2 Z motors in sync.
to extend the cable for the filament sensor I have bought a set of the connectors (XH2.54-3P) Anycubic uses, so I do not have to cut the wire. But u can extend it any way you like. To manage the extended cable I have used the clips that came with the printer and printed some extra (https://www.printables.com/model/631197-anycubic-x-axis-cable-clip-for-kobra-2-kobra-2-max)
if you want bearings on your spool holder I can recommend this https://www.printables.com/model/382008