BTT Manta E3EZ DIN rail mounting plate

A mounting plate for the BIGTREETECH Manta E3EZ V1.0 controlboard to attach it to a DIN rail. This mounting plate is designed around the DIN clip (pcb_din_clip_x3.stl) used in Voron electronics bays like in the Voron 2.4r2. To use this mounting plate you need to print two of these DIN clips.

As I felt in my use case (DIN rail/controlboard mounted upside down) that only using four attachmentpoints for screws to the board was not enough, so I desgined the mounting plate to also use two of the screws used to attach the CM4/CB1 unit. The screws provided with the Manta E3EZ controlboard to attach the CM4/CB1 unit are long enough to pass through the Controlboard PCB and stick out far enough to be used as additional attachment points. Just press on the mounting plate until the screws grip on the plastic and cut their own threads into the plastic.

With regard to the screws you need:

-4x M2x10 Self-tapping screws - to attach DIN clips to the mounting plate
-4x M3x6 (or M3x8) SHCS Screws - to attach the Manta E3EZ controlboard to the mounting plate
-The provided screws for Manta E3EZ to attach the CM4/CB1 unit.

This mounting plate is around 10-12g (as PrusaSlicer 2.7.1) in material. 
Printsettings (personal go to settings):
0.4mm nozzle, layer height 0.2mm, 4 walls/perimeters, 4 top/bottom Shells, 25% infill

The print in the pictures:
Filament: eSUN PLA+ Black (or use ABS/ABS+)
Printer: Voron 2.4r2

Designed based on the board specifications (Drawings) provided by Bigtreetech.

The F3D and STL files are provided, so fell free to alter to your needs.