Ikea Billy Mounting Brackets Filament Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to install mounting brackets for Ikea Billy shelf turning it into a filament rack.
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 1302
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I created left and right side brackets so there is a small gap at the front in case you'd like to add an air tight sealing to the doors. Length is 260 mm so you can print both brackets at once on a Bambu Lab printer for example.
Add some support for the pin holes. This is a snug fit - you'll need to hammer in the pins provided with the shelf. No glue or screws needed.
Use a wooden rod (or other tubing) with a diameter of 22 mm. Cut them to a length of approx. 763 mm (measure the inner width of your shelf minus 2 mm), but this may vary.
UPDATE:
Added left and right bracket for hinge areas. You can either use them above or below. Maybe need to adjust hinges a tiny bit. Print with support.
Print settings:
Prusament PLA Galaxy Black, 220/55, 0.4 nozzle, 2 Walls, 15% cubic infill, automatic support (standard).
Print time: approx. 1:25 h for 2 brackets.
Note: this version does not work with the most recent Billy shelf as they use different pins.