TBRC Warlock P38 Open Cockpit and electronics cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Open cockpit which is a remix of this one: https://www.thingiverse.com/thing:4027253 There's enough room for a servo…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 184
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Open cockpit which is a remix of this one: https://www.thingiverse.com/thing:4027253
There's enough room for a servo with a camera on top inside the cockpit. My build uses a DJI camera and Caddx vista. The extended rear of the cockpit is to cover an electronics bay where I fit a Matek F405 wing board.
The hinge is two parts printed separately and one piece must by glued to the front of the cockpit bottom. I used CA. The other part is embedded and glued into the fuse of the Warlock. Use a thin rod (small servo control rod) as the hinge.
I included the screws which I used ( found elsewhere on thingiverse as well). They screw into these: https://www.amazon.com/gp/product/B073NYMMYD/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2.5
Rafts:
No
Supports:
Yes
Filament: Hatchbox ABS Black
Category: R/C Vehicles