1 / 7
esp32-cam nozzle cam for anycubic kobra 2 series — zdjęcie 1
1 / 7

esp32-cam nozzle cam for anycubic kobra 2 series

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clips on to the side of the printhead. v2 with in-place focus adjustment

Ocena
0 / 5
Polubienia
9
Pobrania
63
Wydruki
0
Wyświetlenia
1156
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Simple and fast printing way to mount a aithinker esp32-cam to the side of a anycubic kobra2 print head. 

No disassembly required. 

Angle of cam is pretty good, lighting is a bit shit, but adding reflective tape inside the “light guide” helps. 

Focus adjustment required.
I sugest using these tools for the initial glue braking: https://www.thingiverse.com/thing:5828103 https://www.thingiverse.com/thing:5027224

For in-place adjustment i made this little wrench.

Adding a ziptie as shown helps with removal. A small hex key also works well using the same gap.

Integrates nicely with esp3d for a 5$ “octoprint alternative”

Without some glue the esp connection aint the strongest, i will probably come up with a alternative solution to this.

Changelog:

V2 (printHead-clip) - Added: SMA Antenna mount, power cable guide. Higher tolerance for push-fit connection.

V2 (esp-clip) - In place focus. extended to length to end with the flex clip handle rather then the start, this allows to change the cam clip to grab the camera at the base rather than the lens, this allows focus adjustment in installed state.

Tagi