1 / 4
Voron 2.4 Side Entry Exhaust Housing for Roomba I7, J8 filters. — zdjęcie 1
1 / 4

Voron 2.4 Side Entry Exhaust Housing for Roomba I7, J8 filters.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of the Voron 2.4 exhaust housing that uses I-Robot, Roomba filters, available at a low cost on Amazon.

Ocena
5 / 5
Polubienia
77
Pobrania
202
Wydruki
4
Wyświetlenia
2677
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

This is a remix of my previous remix, of the Voron OEM exhaust housing.  This one uses Roomba J8 filters, and has a small holder to allow a scissor cut peice of generic activated charcoal filter material, from Amazon, to be installed. 

 

This will need to be printed upside down, compared to the normal print orientation, so you will have to use supports.  I auto generated tree supports in Orca Slicer, and it worked fine.  Well, that's how I printed mine anyway.  You can try it however you like.  If you get good results using a different orientation, please post your results.  This one is a bit tought to print, with lots of steep overhangs.   I used PLA with cooling and supports, and it worked pretty well.

 

You will need the standard Voron exhaust hardware, plus some additional

13 M3 threaded inserts total,  so 5 extra

2 m3x6 socket head cap screws (for the filament tube guide/runout sensor)

1 m3x6 button head cap screw, for the charcoal filter holder.

2 roomba I7, J8, etc, filters.

double sided tape and single sided tape for gaskets.  The same as the OEM Voron exhaust.

Either the bowden tube funnel or the filament sensor, from my previous side entry housing design:  

https://www.printables.com/model/411292-filament-runout-sensor-for-voron-side-entry-exhaus

or

https://www.printables.com/model/396106-voron-24-exhaust-housing-side-tube-entry/files