Rod Loris - Tr8x4 (2 start) leadscrew cleaner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cleans Tr8x4 (2 start) printer lead screws. Based on Rod Sloth.
- Ocena
- 5 / 5
- Polubienia
- 51
- Pobrania
- 418
- Wydruki
- 3
- Wyświetlenia
- 2080
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
The Rod Sloth by NeedItMakeIt is very cool, but my printer, the Anycubic Kobra, has a Tr8x4 leadscrew (i.e., 8mm diam, 2mm pitch, 2-start, 4mm lead.) This is a completely remodeled version of the Rod Sloth that fits this type of screw. Because the design is so heavily based on the design of the Rod Sloth I have marked it as a remix. I did not include all the fancy bits from the original design like the knurling.
See the Rod Sloth page for usage instructions and videos. I used a cut off strip of Harbor Freight microfiber towel, singed the edges where I cut it so it wouldn't unravel further, and carefully pulled off any loose fuzz before running it on the leadscrew.
I recommend 0.2mm or 0.15mm layer heights. I printed mine in 0.3mm layer height and it worked fine, but the threads should be more accurate at smaller heights. I used 10% infill in PLA, 2 perimeters.