Bambu X1/ P1 Expandable Steel Sheet Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix to use m3 heat set inserts instead of m3 nuts and expanded to make it fit the X1/ P1 plates.
- Ocena
- 4,667 / 5
- Polubienia
- 77
- Pobrania
- 307
- Wydruki
- 3
- Wyświetlenia
- 1748
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix that makes this plate holder usable for the X1 and P1 series printers build plates.
I also remved the m3 nuts and put m3 (Voron type - m3 x 5mm x 4mm) heat set inserts in their place.
It's a single 3mf, that contains all the needed parts spread out on 6 plates.
The “Small Parts” plate is set to “By Object” since i wanted to print the button in a different color without printing them separatly or dozens of filament changes. “Slider” and “Arm” are an assembly - this takes up less space due to the “By Object” printing on this plate in case you want to print mulitple on a single plate.
You could skip all this and set the plate to “By Layer” if you print the Slider and Arm in the same color as the Button - which i didn't.
You will need to use countersunk head screws and you may want to countersink the ones for the woodscrews just a bit more, to make them sit flush - depending on the screws you have.
If you have questions about the assembly, check out the original model.