1 / 10
Handle for fuse box hager 90 SL FZ505 / DE=> Handgriff Türverschluss für Schaltschrank hager 90 SL FZ505 — zdjęcie 1
1 / 10

Handle for fuse box hager 90 SL FZ505 / DE=> Handgriff Türverschluss für Schaltschrank hager 90 SL FZ505

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

EN: Replacement handle for Hager switch cabinet DE: Ersatzgriff für Schaltschrank Hager

Ocena
5 / 5
Polubienia
10
Pobrania
172
Wydruki
1
Wyświetlenia
901
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

English description (German description below):


This is a replacement handle for the Hager 90SL FZ505 switch cabinet.

 

Printing:

I printed the part with a Bambu Lab P1S, 0.4mm nozzle, layer height 0.2mm from PLA.Handle-V0 + Body-lower-part-V0 with support material. For even better stability, the lower base body "Body-lower-part-V0" was printed horizontally. In the attached picture you can see how I printed the parts.

 

Assembly:

Glue the lower part of the "Body-Bottom-Part-V0" base and the upper part of the "Body-Top-Part-V0" base with superglue so that the groove of the "Body-Top-Part-V0" axis is aligned with the groove between the two "Body-Bottom-Part-V0" bars.

Remove any burrs from the handle "Handle-V0" and carefully press it into the guide.

Re-install the assembled handle in the door of the control cabinet.

 

No additional parts are required.

 

Thank you for the like and download.

 

Deutsche Beschreibung:

Dies ist ein Ersatzgriff für den Schaltschrank von Hager 90SL FZ505

 

Drucken:

Ich habe das Bauteil mit einem Bambu Lab P1S, 0,4mm Düse, Schichthöhe 0,2mm aus PLA gedruckt.

Handle-V0 + Body-lower-part-V0 mit Stützmaterial.

 

Für noch bessere Stabilität wurde der unteren Grundkörper “Body-lower-part-V0” liegend gedruckt. Im beigefügten Bild kann man sehen, wie ich die Teile gedruckt habe.

 

Montage:

Den unteren Grundkörper “Body-lower-part-V0” und oberen Grundkörper “Body-top-part-V0” so mit mit Sekundenkleber verkleben, dass die Achsnut vom “Body-top-part-V0” in Flucht mit der Nut zwischen den beiden Stegen des “Body-lower-part-V0” liegt.

Eventuellen Grat vom Handgriff “Handle-V0” entfernen und vorsichtig in die Führung drücken.

Den so zusammengebauten Griff wieder in der Tür des Schaltschranks einbauen.

 

Es sind keine zusätzlichen Teile nötig. 

 

Danke fürs Like und den Download.

 

 

Zusätzliche Suchwörter:

Hager Tuerverschluss Schließung universal

Tagi