Tomy Dustbot SO-G front rubber gear replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement for Dustbot's front rubber gear which drives arm movement.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 203
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
A replacement for Dustbot's front rubber gear which drives arm movement.
Print Settings
Printer:
RotricsDexArm
Supports:
No
Resolution:
0.1
Infill:
100%
Filament:
PETG is recommended over PLA for durability.
Post-printing:
You may need to drill the center hole with a 2.5 or 3 mm drill if it fits too tightly over the pin. If so, drill from the top down for the cleanest result.
How I Designed This
Several teeth on my Dustbot's rubber gear were damaged, so I made this replacement. The gear is 3 mm high instead of the original 2 mm in case the bottom layers do not print well, and so they won't break as easily.
Since it is a plastic gear, it makes a bit more noise than the original, and it is a little more difficult to install: You have to lower the gear and motor simultaneously into their respective slots.
Alternatively, you could use this file to print a mold for casting a silicone gear.
The original gear, damaged.
Category: Robotics