Giant Christmas Lights for IKEA Strala
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A giant Christmas Light but for normal sized printer.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 338
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This design is an indoor version of my Giant Christmas Lights using IKEA Strala socket. A great alternative if you do not want to use a solder iron!
*** Please note: the temperature will buildup inside the bulb. I do not think it could be a fire hazard, but the lifespan of the LED will be reduced.
Printing
The printing is simple. The giant bulb is 234mm high. The bulb can be printed with a brim and support “touching build plate only” at the bottom only. NO NEED TO SUPPORT THE TOP! This will save printing time. There is a flat inside at the top for a better exterior finish (at the expense of a darker area). The "Strala key" should be printed on its side for higher strength. Printing at a 0.24mm layer height is good enough.
Assembly
Begin by testing the threads of the bulb. Screw the bulb to the base, ¼ turn at the time. If it gets stuck, go back and forth a ¼ turn. Take your time. Unlike the “Giant Christmas Light” for spotlight, the removal tool I made cannot be used to release a stuck bulb.
The pictures are self-explanatory. You will need 4 M3x10 (or M3x8) screws.