Finger Claw - New Update 1-8-24

Little finger claws for funsies! 

Use with caution as it can be sharp. Not intended for children under 12. May cause injury.

----------------------------------------------------

V2 IS NOW INCLUDED AND FREE!!!!!

---------------------------------------------------

NEW UPDATE!!

Latest version has some changes. See pic for quick reference.

Changes in V2;

• Modified the tip to try and help with printing issues as the old version was too fine and got a little deformed. Hopefully this change fixes that. 
• Adjusted the angle of the claw to provide better standing balance.
• Resized the finger holes to be a smidge larger
• Scaled the model to a more appropriate size when loading into slicers as some people noted it was very small. However, you will still need to scale them to best fit your fingers as everyones vary in size, obviously.
• Did some model rework as there were some minor issues that needed correcting.

Video Timelapse of the claw printing can be found here. The example in the video is scaled up to fit my finger. 

Scale it to fit your finger as the 3D models scale is on the smaller side. Designed em for finger tips, but they can be scaled up to easily fit your finger tip or to slide past a knuckle or two for a little variation! 

Orient them to whatever works best for your slicer/printer settings or needs. Printing from the base up with brim should be fine for most

Settings I used that match the video.

Bambu X1C

• .20 Strength
• Printed with Brim
• 100% infill - You can definitely use less without issue, but I wanted a solid prototype ;)

Happy Printing!!