"Clicky" Hit Point and Spell Slot Trackers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hit point tracker and set of spell slot trackers for tabletop RPG's, especially Dungeons and Dragons.
- Ocena
- 4,667 / 5
- Polubienia
- 36
- Pobrania
- 171
- Wydruki
- 5
- Wyświetlenia
- 1207
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
These hit point and spell slot trackers let you store your character's consumables without repeatedly writing and erasing, wearing through your character sheet. Click mechanisms in the dials keep the numbers in place, so toss them in your bag at the end of the session and trust they'll be in the right place when you pick up again. And grips on the ends make it easy to hold with one hand while changing values with the other.
The hit point tracker has three digits, so any reasonable character's hit points should be taken care of into very high levels. Print an HPT core, two grips, and three dials.
Three spell slot trackers are available - for spell levels 1-3, 1-6, and even 1-9 for your try-hard wizard. Print 1, 2, or 3 SST cores, 3, 6, or 9 dials, and two of grips A, B, or C.
Printable without supports with any filament you like (but probably not with an SLA printer). Consider a brim on the cores if your printer has stability or bed adhesion issues. If you want more or fewer digits, shorten or lengthen the Z-height on the cores by 12 mm for each dial. Plenty of clearance between dials, but you can shorten the cores by about 1 mm to tighten them up.
For easy photography, I recommend printing in a non-reflective material. (sigh)