Levelling shim for Creality LD002-R
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fix for skewed build plate / impossible to level Creality LD002-R
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 237
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The build plate on my LD002-R lifts on one side when tightening the screws. The reason is that there is a measurable gap (shown as “gap” in one of the photos) that causes a bend in the build plate bracket.
An obvious solution would be to not tighten the screws, the second most obvious is to make a shim as shown in the video. Time will tell if the problem is solved, but it looks good for now.
Start by measuring the gap as shown by the red arrow in the photo.
To print, import the shim into the Prusa slicer and set the slicer to the lowest possible layer height. Adjust the z height of the print to the size of your gap. You may have to fiddle a bit back and forth depending on the precision of the print, and possibly make a higher one and sand it down to size.
Once the shim is the right size, use it to fill the gap to prevent the build plate bracket from bending when tightening the screws, and hopefully your problem is solved.
Simple but hopefully illustrative video: https://youtu.be/-bXrazXOQtA