BBQ Food Probe Spool w/Magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is food probe spool that has spots for 12mm magnets so that the spool can be conveniently stowed.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 114
- Wydruki
- 2
- Wyświetlenia
- 552
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
This is yet another BBQ food probe spool that I designed with specific features that I wanted in my design. This design features ‘pockets’ for 12mm magnets. The pockets are 3mm high, so I stacked 3x12mm magnets and pushed them into the pockets. In my experience, I only really needed two stacks of magnets to hold this to the side of my grills hopper very securely.
Printing:
I printed using PETG (since these will live outside primarily) at 0.28 layer height. The only part that needs supports is the bottom. I would recommend tree supports that are ‘touching the build plate only’. I've personally blocked supports on the probe holster portion on the side.
Note that the bottom and top layers are very thin (so that it's easy to get the magnets slid into the pockets and have a bit of a friction fit. These layers may be fragile, so be careful when removing the support material. You may also choose to dab some glue into the pockets to keep the magnets in.
The top portion prints with no supports just fine.
Assembling:
Simply push the top half into the bottom half until it clicks into place. The tolerances are darn near perfect on my prints, but your mileage may vary. This should result in a very snug fit.
Using:
Use as you would any other BBQ spool, putting the probe into the holster in the side, and winding the wire around the center of the spool. I've added some holes in the center to dock various sized phono plugs.