RAM HD 2019+ 12" radio upper cubby Rubigrid base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a base for a Bulletpoint Rubigrid mount that will tilt and raise the mount to clearance the radio bezel trim.…
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 1
- Wyświetlenia
- 411
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
This is a base for a Bulletpoint Rubigrid mount that will tilt and raise the mount to clearance the radio bezel trim.
RAM HD 2019+ 12" Radio cubby
I designed this from scratch using Fusion 360
Sliced with Prusa
Printed in PETG on an Ender 5Plus
Print a prototype in PLA if you need to test fit. Print with the top (entirely flat) face down, feet up.
Printed without supports for the inside slots that the Rubigrid base tabs fit into so this area may need a little relief due to material sag. I used a small Dremel end mill.
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
No
Infill:
15
Filament:
SUNLU PETGBlack
Notes:
I like Gyroid fill for strength and coverage, try it!
How I Designed This
Fusion360
I designed this from scratch using Fusion 360, started with a sketch with multiple constraints for sizing and locations and built it from there.
Category: Automotive