1 / 6
360° Animal repeller Flashing and noise , WIFI enabled — zdjęcie 1
1 / 6

360° Animal repeller Flashing and noise , WIFI enabled

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Made it to scare away wild boars. Super bright if LED voltage is cranked all the way up so careful around public roads…

Ocena
0 / 5
Polubienia
2
Pobrania
14
Wydruki
0
Wyświetlenia
157
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

Made it to scare away wild boars. Super bright if LED voltage is cranked all the way up so careful around public roads and stuff.

Simple print with almost no supports needed and cost should be around 20$

Parts list:

Pir sensors 3pcs: https://s.click.aliexpress.com/e/_DlUd6l7

Power switch 10x15mm: https://s.click.aliexpress.com/e/_DEkuDuz

Charge port Connector jack: https://s.click.aliexpress.com/e/_DkGAGWz

LED chips 12V 10W: https://s.click.aliexpress.com/e/_DFQyTEt

For the sound i used five of these: https://s.click.aliexpress.com/e/_DcJdLwp

Just wired them up in parralel with the LED-s

Boost converter to drive the leds: https://s.click.aliexpress.com/e/_DmUj7pP

You will need 2s battery pack to be able to drive the LEDs full power

The case fits 4 18650 cells comfortably and i used this balance bms to build a pack from some used cells: https://s.click.aliexpress.com/e/_DkoSa69

A mosfet to switch leds, i used: https://s.click.aliexpress.com/e/_DkfOt2p

You can use your favorite microcontroller but i used the esp32 with the external antenna connector like this: https://bit.ly/3THwJMZ

You will also need diodes on each of the trigger pins on the pir sensors otherwise they will backfeed into eachother

Category: Electronics

Tagi