Sovol SV05 Front Brace Relocator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Moves the top front brace down to your desired location.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 411
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
The upper front brace on the SV05 is, well, in the way. The brace keeps me from getting a good look at that first layer. Moving the brace down a bit would sure help. And that's just what this model in intended to do.
Upon removing the brace you'll find it was needed to keep the top corners alligned. No you'll need to install the left and right braces first. Use orginal hardware for this. At this point you could be done; just the brace off completely. But you don't want to stop here!
Before printing the brace holders, you may want to print the TEST piece. The aluminum extrusion will be a very tight fit. The square hole was drawn up to accept exactly 20x20mm extrusion. The reliefs in the corners should provide wiggle room for excess filament during the printing process. Provided the extrusion fits (verifying your printer calibration), go on to print two of the FrtBarLocators. I used 4 M5x10 screws and t-nuts to secure this to the frame.
I printed my parts in ABS. However, I would think PLA will work fine.
Harware needed:
4 M5x10 screws/bolts
4 M5 t-nuts