Ryobi EZClean Pressure Washer Accessories Wall Organizer

This is a wall mounted holder for the Ryobi EZClean 18/40v handheld pressure washer accessories. I designed this to hold a spray wand(or wand extension), 3 spray heads, the soap sudser, and the angle adapter. And if you have the bucket hose with the mesh bag, you could also hang that on one of the hooks.

I mounted it to my wall using 46mm drywall screws and a couple of drywall anchors.

I also included a second version that I created after printing the first in an effort to somewhat reduce the amount of filament required (V2 uses 17g less than V1 with the settings I used). I also noticed that the wand/extension holder was a little tight to insert in V1, so I made a slight modification that should help with that.

I used mostly default settings with my BL P1S in Orca Slicer using Sunlu PLA+.

Here's what I changed:

• 4 Wall Loops
• 4 Top Layers
• 4 Bottom Layers
• Mouse ears for the corners instead of full brim, though you may be fine without any brim
• No supports are necessary

The model is just a hair over 229mm wide so if your plate is any smaller, you may be able to make it fit if you rotate 45 degrees depending on your plate size.

I haven't printed V2 yet to see how it compares to V1, but if you do, please let me know how it goes.