MicroBeads Energy Pack: only platics generator (NOT EMG)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An energy generator (NOT EMG) with only plastics that is suitable for low frequency environmental energy, print in place
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 113
- Wydruki
- 0
- Wyświetlenia
- 1008
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Triboelectric nanogenerator (TENG) is a new type of generator for “green energy”. In our study, a novel “pause-and-insert” and “print-in-place” 3D printing approach has been devised, employing widely available fused deposition modeling (FDM) printers along with conductive (as electrodes) and nonconductive (for casing and support) filaments to make encapsulate microbeads triboelectric nanogenerator (MB-TENG).
YouTube channel www.youtube.com/@TENGBINN
Reddit discussion https://www.reddit.com/r/3Dprinting/s/WDL5EnmvwS
More detail:
Paper title in Materials Today: Fully enclosed microbeads structured TENG arrays for omnidirectional wind energy harvesting with a portable galloping oscillator
DOI address in google scholar: 10.1016/j.mattod.2023.11.001
Printing process:
The Prusa mini printing setting and g-code with material change are attached. You start with conductive materials, change to normal PLA at about 5 mm, when finished (at 6 mm), during the material change, insert the beads manually, then change to conductive material at 6 mm and finish the print . A 54-beads pack takes 1h13m.