UFS-082 BSi Two-Part Epoxy Bottle Holder - Bob Smith Industries
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I liked my CA glue bottle holder https://www.thingiverse.com/thing:4604158 I decided to make one for my epoxy glue…
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 44
- Wydruki
- 1
- Wyświetlenia
- 301
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I liked my CA glue bottle holder https://www.thingiverse.com/thing:4604158
I decided to make one for my epoxy glue bottles.
For me, this holds the 4.5 oz., two-part, quick-set epoxy from Bob Smith Industries, about 35.5mm diameter. (Other epoxy bottles of similar size should fit, but I don't have any to test.) This BSi epoxy is a good adhesive but I think any two-part epoxy is better than most glues.
I decided to make several major changes to my first design. I went with a narrower base in order to take up less space. I added a barrier between the two bottles. Then I added a hole through the barrier to create a handle.
The bottles fit easily inside the holder. The handle is convenient for moving it around. I like the barrier between the two parts that you don't want to mix until it is time. Overall, I am satisfied with the design.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
No
Supports:
Yes
Notes:
I blocked supports around the bottom. I only used support for the round opening in the center piece.
Category: DIY