Vizio E32-D1 Webcam Foot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Much nicer up out of the way.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
While I was cleaning up my garage I found the feet for my cheap TV that I have hung over my monitors and realized I could move my webcam off my monitors and up to the TV instead.
Took the calipers to the foot and recreated it, shot a 3" extension out from it, gave it a little reinforcement to stop it from sagging with time, and rounded the edges off. Fit beautifully using some random screws that matched up with the factory holes (I lost the originals), I think they're like M5x40's.
You'll need a 1/4"-20 bolt of some kind (standard fare for camera mounts) to secure your webcam or whatever you'd putting on it. I had a thumb screw from an old tripod that did the job perfectly, basically one of these. There's plenty of clearance for it to have some wiggle room as the hole is ∅7.35mm (1mm larger than 1/4").
Print it on it's side with whatever settings you'd like. I did mine with 0.2mm layers and supports for the holes just 'cuz, but they really aren't all that necessary.
Apparently this would be usable on multiple Vizio TV models, including D32H-D1, E32-D1, D32F-E1, D32F-F1, and D28H-D1.