Marvin the Martian
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed some of this model with permission.
- Ocena
- 0 / 5
- Polubienia
- 51
- Pobrania
- 126
- Wydruki
- 0
- Wyświetlenia
- 656
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Characters & Monsters
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Summary
Helmet is a remix of reddadsteve's Marvin print. I tried to do it myself but he is the master, so he gave me the thumbs up to post this as a remix. No match to what he does but just a fun one to print. Just paint the eyes and shoe's to complete the print. The ray gun was idea from another Lego miniature I had so made it on Tinkercad. Main Lego parts from thingiverse 2936306. A little sanding, shaving, or tweaking may be necessary depends how dialed in your printer is. ENJOY!!!!
Note
On the Legs you can start out with white, after it finishes the top layer of the foot you can change out to red. That is if you want to keep painting to a minimum. On the black colored areas you can always use a good quality thin point black pen or sharpie that wont run into the grooves of the print.
I put two skirts one with an indention and one other plain. The one with the indention just sits it a bit lower bit of course not much.
This STL is not to be sold or distributed without authors consent.
Everything should just slide into place.
Didn't make the wheels roll on this one.
Have fun Printing folks!!!
If you'd like to leave a tip: PayPal.Me/3DCopper