Fantasy Tavern 1 - Split for smaller printers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is just the beautiful model of a tavern split up to fit smaller printers. So on my 222x222mm printer those print…
- Ocena
- 5 / 5
- Polubienia
- 113
- Pobrania
- 565
- Wydruki
- 2
- Wyświetlenia
- 2278
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Architecture & Urbanism
- Licencja
- Creative Commons — Attribution — Share Alike
This is just the beautiful model of a tavern split up to fit smaller printers.
So on my 222x222mm printer those print beautifully.
Since cura had some issues with the big stl-size of the roof-2 and roof-3 there are also .obj files which seem to work fine.
Print Settings
I had some really big issues printing the roof, so I would recommend to turn off "Drop to build plate" and lift the models 5mm off the build plate, set the "Support Placement" to "Touching Buildplate" and the "Support Overhang Angle" to "10".
This will make sure the whole model gets supported and having it on supports above the build plate compensates for some warping, so when you remove the model from the support it is completely flat.
Category: Buildings & Structures