Raspberry Pi + 5 Inch Screen Case (RetroPie Console)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for my portable RetroPie console. It's for a Raspberry Pi 3B+ and a OSOYOO 5 inch DSI screen.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 96
- Wydruki
- 0
- Wyświetlenia
- 2966
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is a case for my portable RetroPie console. It's for a Raspberry Pi 3B+ and a OSOYOO 5 inch DSI screen.
Feel free to modify the Fusion 360 Model for your needs.
Detailed Description
A detailed description on the setup, the used software and history of the project in my blogpost: RetroPie Revision 2
Hardware
Below is a list of hardware components used in this project. The links go to AliExpress, but you may also find them at Amazon, eBay or your preferred hardware dealer.
- Raspberry Pi 3B+
- 5 Inch DSI Touch Screen
- Speaker 50mm 8 Ohm 2W
- 30x30 5V Fan
- 2mm LEDs
- short HDMI Cable
- i2s Audio DAC breakout
- Micro push buttons
- 2N2222 Transistor
- Resistors
- 8BitDo Zero
Print instructions
Printer Brand: Prusa
Printer: i3 MK3
Rafts: Yes
Supports: No
Resolution: 0.2mm
Infill: 15%
Filament: DasFilament PLA Metallic Red
You want to print with a brim to avoid any warping at the corners. I printed the base using "Octagram Spiral" as the bottom layer pattern to make it a little more interesting to look at.
Be sure to flip the lid by 180 degrees before printing. No supports needed.