1 / 1
Vacuvin Vacuum Adapter — zdjęcie 1

Vacuvin Vacuum Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter for a Vacuvin bottle stopper, can be used in order to easily create a vacuum filament storage box.

Ocena
0 / 5
Polubienia
4
Pobrania
12
Wydruki
0
Wyświetlenia
150
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

About

A simple 2-part adapter that can be installed in the lid of a (sufficiently strong) sealed storage box, so that the box can be pulled to a near-vacuum.

Printing

  • ABS (advised), PETG or NYLON (hard)
  • Print using a ‘strength’ profile, with 6 wall loops
  • 25% infill
  • 0.2 layer height
  • You can optionally smoothen the inside of the tube using a polish or acetone vapor, for a better seal with the Vacuvin stoppers. Didn't have to do so myself.

Installation

  • Drill a 23mm hole in the lid of a box, preferably in a structurally strong location (near a corner). Drill 6mm holes where the bolts will go.
  • Apply transparent silicone where you will place the adapter on the box, on both sides. Alternatively you can use a big O-ring on the outside, between the lid and the top-adapter. It should be 4cm in diameter and go around all of the bolts. You should apply a second O-ring around the inner tube to compensate during tensioning.
  • Insert the larger adapter from the outside, with the tube part inserted in the 23mm hole.
  • Order of installation, top to bottom:
    • Outer adapter ring with tube downwards
    • Sealant (rubber or silicone)
    • lid
    • Sealant (rubber or silicone)
    • Inner adapter ring
  • Finally, fix using M6 bolts (outside) and nuts (inside). Tighten well, but do not overtension.

Use

Closing

  • Close the box by putting the (sealed) lid on. Insert the Vacuvin stopper in the tube and use the hand pump (or a vacuum cleaner) to create the vacuum.

Opening

  • Release the vacuum by pinching the vacuvin stopper and letting in new air
  • Open the lid

Tagi