1 / 3
Raspberry Pi 4B case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple and tool-less case for the Raspberry Pi 4B
- Ocena
- 3 / 5
- Polubienia
- 7
- Pobrania
- 228
- Wydruki
- 1
- Wyświetlenia
- 1258
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- GNU General Public License v3.0
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (0)Kolekcje (20)Powiązane
You should not need any other equipment to install the Pi, it should snap-fit in with tight tolerance. The screw holes are 1.3 mm diameter, but are not required.
Once the Pi is set, you can snap the lid into place. It is recommended to put the SD card in after the Pi is set in the base just to make installation much easier.
This is my first 3D model, any feedback is appreciated!