Jeep TJ Roll bar Dashcam Mount

After upgrading to a newer dashcam, I wanted the ability to use my older dashcam (Viofo A119) for rear-view recording, but with a Soft Top, rear-view windshield mounting is impractical.

To get the Dashcam to stick to the mount (like you would on a windshield), I affixed the clear windshield mounting sticker (provided by Viofo) to the flat of the 3D printed mount with 15 minute epoxy. I then used the 3M Tape/Sticker (provided by Viofo) to affix the GPS Dashcam mount to the windshield sticker (like you would if sticking directly to a windshield).

I printed mine with PLA and haven't had any problems, but you may want to use PETG or other higher temperature filament if you expect high interior vehicle temperatures.

I used Zip ties to attach the mount to the roll bar.

I designed this to work on a 2005 Jeep Wrangler with factory padded roll bar. This should work with any TJ model (with padded roll bar). Just in case though, I recommend cutting a small test slice/piece off the model in your slicer program before printing the entire model to make sure the diameter fits correctly).

Printed with:
-PLA
-15% infill
-Print on side (Default orientation)
-Supports required