Small Tapered Dog Bowl Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raises dog bowl 90mm and fits bowls of approximately 110-116mm diameter lip
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 230
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pet food bowl riser. Elevates you pets food bowl off the ground. Raises dog/cat bowl 90mm and fits bowls with approximately 110-116mm diameter lip.
I printed in PETG, PLA would be fine also. You can print hollow or with minimal infill, it will be structurally sound either way. I printed with 10% Support Cubic, which only added a few minutes to the print. The taper and double wall are probably all the support that's needed, and the taper gives it tipping stability. But the tapper is small enough that the pet can still easily reach into the bowl.