HSW Rod Sloth Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the excellent Rod Sloth Z-screw cleaner, for hex mount on Honeycomb Storage Wall
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 86
- Wydruki
- 5
- Wyświetlenia
- 652
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Rod Sloth is a brilliant cleaner for Z-screws…
https://www.printables.com/model/605305-rod-sloth-fits-most-3d-printers
I have a Honeycomb Storage Wall so designed this holder to store the Rod Sloth on the wall by my printer.
I used the original hex pattern from the HSW designer which tapers very slightly. This had the odd effect of giving the base of my holder a very slight angle too, which I didn't spot until I sliced it. There was no easy way to correct that in Fusion360 so instead all you have to do is check your slicer's bottom layer, and if there's a step in the bottom of the holder just lower the model -0.1mm into the build plate and reslice it and then it should be flat on the plate and cause no adhesion problems. The 3MF file has the model set correctly on the plate but check it hasn't changed any other settings or load your normal profile after importing it. If you use the STL you'll need to check the bottom layer is flat.
I used 0.2mm layers, 0.4mm nozzle, 3 walls, 15% infill, no supports, all standard settings. I'd imagine any reasonable settings would work fine.