Japanese saw holder french cleat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds two japanese saws on a french cleat wall
- Ocena
- 4,5 / 5
- Polubienia
- 38
- Pobrania
- 182
- Wydruki
- 2
- Wyświetlenia
- 1241
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Well…holds two saws.
After some testing I must say, it works really well.
Prints without supports.
Just print the holder with the holes pointing down and you will be fine. PLA, nothing special.
The cylinders must be printed in TPU to reliably hold the saws. Tried steel balls, but those dont have enough friction.
Both with 0.2 layer height and 5% infill.
Put the cylinders in the holder (through the holes) and make sure, that they are able to “roll down”. Insert saw from below, gently pull the saw down so it will be trapped between the TPU cylinder and the holder…there you go, the saw is secure.