Automated Pet Treat Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3d printed 7-slot pet treat dispenser
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 522
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
These are the printed components I needed to make this automated pet dispenser.
Additional Parts Needed:
- 1x 28byj-48 stepper motor. I purchased mine here
- 1x ULN2003 driver board, the bundle above includes them
- 2x m3 machine screw
- Any raspberry pi
Assembly:
Assembly is fairly straightforward. Start by inserting the motor into the base, then place the shell on top of it. Make sure the triangular cutout at the bottom of the shell aligns with the raised lines on top of the base. Then screw the two m3 screws into the bottom of the shell. The divider can be attached to the motor at this point, it should be fairly snug. Lastly, the cap can be placed on top of the shell
I've also posted the code necessary to run this project on my github