Shoe Rack/Filament Rack Height Adaptor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For use with this rack: https://www.amazon.com/dp/B0CN6LPG42?th=1
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 156
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
DO NOT USE SUPPORTS. It will make the inner parts bind together and you will have to drill it out. If you need supports, it's not orientated correctly.
I made this to allow more room to store spools of filament in an upright position rather than laying them on top of one another.
~~~~PRINT ONE BEFORE PRINTING MULTIPLES TO MAKE SURE YOUR PRINTER IS CORRECTLY SIZING THEM~~~ If it doesn't fit, just scale 3-5% in your slicer bigger or smaller. Once you know it fits, turn your printer into a little adaptor factory :).
Print Settings:
100% Infill, (they need the strength, 100% is the safest, albeit a little overkill).
Filament: I used PLA, it's all I have on hand right now, but PETG would be ideal.
Supports: This model was made for me and the people on Cinderwing3D's Discord, so in true Cinderwing3D fashion, it does not need supports if the orientation isn't changed. (print with the face that has the 6 pin collet visible, face down. Fillets and chamfers have been put in place to avoid any supports needed).
Layer Height: .200
- It is a snug fit, may have to push hard depending on your printer, (be careful, it may get stuck and you will have to break it off or use pliers, etc).
- It has an overhang that closely matches the radius surrounding the vertical mounting holes on the corner, this is for more strength given the height of the unit, (not much stress at the top, but at the bottom will be the most stress, obviously, lol) Orientate so the flange matches the radius around the hole for installation, (photo included).
- The rods that come with it has an Inner Diameter of 11.63mm and a internal flange of 10.50mm on the ends of the rods, (give or take, I doubt they hold the tolerances very tight, so again, your milage for fitment may very). The 6 pieces inside of the model have a flange to match the internal ID after the flange, they can flex slightly during install to help with more strength.
- Multiple size heights included. The 11MM allowed me turn the spools of filament while putting them on the rack, and then turn again to stand up straight. If that is still too small, bigger extensions are included.
- The overhang allows for easier removal if you just rotate it before pulling, it gives you a handle.
- Message me if you something isn't right. :)
- If you use all of these on all the rods, be careful, it may make it too tall and unstable.