Universal parametric GENELEC speaker stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I found this https://www.prusaprinters.org/prints/4356-genelec-8020d-speaker-stand But it is wrong size as I need…
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 150
- Wydruki
- 1
- Wyświetlenia
- 2062
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I found this https://www.prusaprinters.org/prints/4356-genelec-8020d-speaker-stand
But it is wrong size as I need stand for 6010A and 8030A. So I draw my own universal parametric project. You can use this as hollow or filled with sand as there is model with a floor and lid. (Please note that I have NOT printed bigger with the lid yet!)
If you have measurements (widest width between top studs (mid to mid) and the measurement from front stud to back please provide so I can add more sizes.
Print instructions
Provided 6010A gcode is printed:
Printed on: Prusa 3D i3 MK3S
Filament: Prusa generic grey
Slightly modified 0.30mm DRAFT MK3 preset for the speed:
Layers and Perimeters:
Perimeters: 3
Solid Layers Top: 4
Solid Layers Bottom: 3
Infill:
Fill Density 20%
Fill Pattern: Grid
I thought there will be no issue with standing waves as this is so small stand. But...
As suggested in 8020D version you might want to use:
Layers and Perimeters:
Perimeters: 4
Solid Layers Top: 5
Solid Layers Bottom: 5
Infill:
Fill Density 20%
Fill Pattern: Gyroid
Use these settings to make sure the whole structure is firm and will not allow any acoustic problems like standing waves etc. in the bigger and taller versions of the stand.