Elegoo Saturn 3 Ultra Resin Printer Cover Riser

The Riser provides a method to add a  small power cable (12v or 24v etc) for an internal optional heater, that can be added to the Elegoo Saturn 3 Ultra Resin printer. The Riser removes the need to drill an access point into the printers cover, therefore no modifications to the printer or cover is necessary. It also relieves the need to use the cover's auxiliary air duct port as an avenue to enter with a cable. It is printed in 8 major parts, 4 minor parts and 20 alignment pin parts. Not all pins may be necessary, use your own judgment while assembling. Due to its nature, size and over hangs and i found no other way to print  the unit as fewer prints unfortunately. I did try other methods but the results were less then ideal. I have supplied the Bambu Studio 3mf file and 11 STP files for other slicers. Included is a PDF with illustrations on how to put the parts together. I used hot glue to adhere all parts together. The unit when fitting to the printer is snug. A bit of pressure may be required homing in all sides when installing. IDK if this fits regular Satin 3 Resin printer as i don't have one to test.  The fit of the printers cover on the Riser, should be no tighter or looser a fit, then when used without the Riser. 

NOTE..I have a designed a pair of heater brackets LH and RH for an off the shelf heater for this printer and have not included it here, as users may choose to use a different heater module and use a different method to heat with, but the Riser will still give them an avenue to get a low power cable into the printer. I will post those brackets and its necessary accessories as a different post!