Saturn 3 Ultra Resin Printer Heater Brackets for Left & Right Side Top Mount

A pair of heater mounting brackets for the Elegoo Saturn 3 Ultra Resin printer, using a specific pair of off the shelf 12v 5 amp heater units. 

https://www.amazon.com/dp/B0BL6WZPM9?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B0CMQ8GPY7?psc=1&ref=ppx_yo2ov_dt_b_product_details

The units must be purchased separately  and ship with a Heater, 12v 5amp PSU and power cables

The brackets are one part print file for each side  left and right, that are simply hot glued at the top of the Z frame and on the side of the Z frame. The Heaters firmly press fit into the brackets.

To prevent drilling holes into your printer for power cables for the heaters, use the Riser i created 

https://www.printables.com/model/714046-elegoo-saturn-3-ultra-resin-printer-cover-riser

As the Saturn 3 Ultra Resin printer uses a Carbon Filter on both sides, the brackets accommodates the fitting of the heaters above the filters. 

NOTE:…. 

1. Use Hot glue to adhere the brackets as other glues will be difficult to remove if that need arises. 
2. You will need to modify the supplied power cables for the Heaters, as the shipping cables will potentially get knocked on the right side heater by the cover. The left hand heater is snug against the Z frame and bending the cable to force fit,  will break it. You need to cut the heater plugs off the cables and prepare them to expose the 2 terminals. cut the terminals shorter and test fit them into the shrouds for fit before doing any soldering.
3. You will need to add an additional hole in the riser model (downloaded seperate), if you wish to use 2 separate PSUs, one for each heater as shipped, or obtain a 12v 10 amp psu and create a new harness with the cut off plugs using a 14 awg wire gauge. WARNING!! using the Barrel connector of one supplied cable to feed 2 heaters is not recommended as the Barrel Connector for one cable is insufficient to carry the load of 2 heaters!!!!! It will get HOT!!!! THE IMAGES SHOW A NEW CREATED HARNES USING ONLY THE PLUGS FROM THE SHIPPED CABLES AND IS SPLICED IN A CUSTOM JUNCTION BOX BELOW.
4. The supplied 3d printed Shrouds (3 parts) is supplied for this, but requires the user to have soldering experience and some epoxy or a hot glue gun. It is required to add the 2 shroud parts onto the Right cable before resoldering and the 1 part shroud onto the left cable before resolder it. After resoldering, then apply hot glue/or epoxy into part 1 and quickly insert the soldered plug into Shroud part 1. After that  fill Shroud part 2 with hot glue/epoxy and slip it into place. Repeat with Shroud part for left side. (SEE IMAGES OF PLUGS ETC) The completed Shroud assembled will tightly hug the corner of the heater.